Acrow Prop Needles (1.2 Metre)
Acrow Prop Needles, are designed as a safe masonry support for larger opening up to 450mm.
1.2 Metre in length our Acrow prop Needles have been designed to be used with two Acrow props in fixed safe slots. Tested to have a a SWL of 1050KG, compared to conventional needle supports/ rsj offcuts commonly used in the industry, with no Load rating.
£87.99 (£105.59 Inc. VAT)
ADDITIONAL INFORMATION
Acrow Prop Needles are designed as a safe masonry support for larger opening up to 450mm.
1.2 Metre in length our Acrow prop Needles have been designed to be used with two Acrow props in fix safe slots. Tested to have a a SWL of 1050Kg, compared to conventional needle supports/ rsj offcuts commonly used in the industry with no Load rating.
USER GUIDANCE
Length 1200-170-62mm 27KG (Less than one brick space width and height.)
Masonry support up to 450mm.
Maximum working height 3 Metre.
Two person required for safe install.
Designed to be used no more than 900m apart (may need to be spaced closer with un-balanced Loads.)
The Acrow prop Needle can be used on 1 prop , with the other side resting on a spreader block or Scaffold board on a existing floor , if this method is used make sure the joist/floor is supported with props underneath the load bearing point of the resting Acrow prop Needle.
Our Acrow prop Needle has been tested on Acrow props And independently of prop, the SWL is 1050Kg loaded up to 450mm of centre.
When installing the Acrow prop , there is an slot opening at the end of the Acrow prop Needles insert until prop hits profile guide and has dropped into top plate. the only way to realise the Acrow prop Needle is to lift until it hits bottom plate and slid out.
IF IN DOUBT ABOUT USER ADVICE PLEASE FEEL TO CONTACT US. IF STRUCTURAL ISSUES CONSULT YOUR STRUCTURAL ENGINEER.





